Crow Runner Link Uživatelský manuál stáhnout pdf (Strana 15)

RUNNER LINK Gateway Configuring the Runner Link

Click the

button.

The screen closes and only the green SYS LED continues to blink. The

other two LEDS are OFF.

10. Set the IP of your laptop back to your normal working IP.

11. Disconnect the cross cable from the Runner Link and connect the Runner

Link to the LAN or WAN.

Setting the Board to the Factory Default IP Address

1. Using Figure 3 on page 6 as a guide, short the Reset jumper pins using

the jumper installed on one of the pins.

2. Press the CONFIG button.

The board is now reset to the factory defaults.

NOTE

You can also reset the Runner Link by turning on power to the

board when the pins are shorted using the jumper. You can then

remove the jumper and plug it onto one of the pins for safe

keeping.

Setting the RUNNER panel with Account code and activate the dialer

The next steps are very essential in order to enable delivery of RUNNER panel

events to the monitoring center station:

1. Enter to the RUNNER panel Installer mode

2. Define the account number: P62EXXXXE (XXXX=Account Number)

3. Activate/or verify activation of the dialer : P175E1E

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 30 31

Žádné komentáře

Crow Runner Link Uživatelský manuál Strana 15